There are so many variables when it comes to firearms- the type of gun, the ammunition used, the environment in which it’s used- that any generalized instructions could be disastrous.
But we will do our best to provide you with a comprehensive guide on how to clean your Glock 19. Just remember, always consult your firearm’s owner’s manual before attempting any cleaning or maintenance procedures.
-
How To Clean Your Glock 19 – A Step By Step Guide
First and foremost, it is important to understand that there are different ways to clean a Glock 19- depending on whether you have the original factory barrel or aftermarket barrel.Â
We will cover both methods, but please note that some steps may vary slightly depending on which barrel you have installed.
Remember that regular cleaning won’t matter if you don’t maintain the gun regularly, you avoid using appropriate Glock 19 ammo, and in general, treat it like a toy.
Also, always make sure your gun is unloaded before starting any cleaning procedure! With that out of the way, let’s get started:
If you have the original factory barrel installed on your Glock 19, disassemble the gun by removing the magazine and pulling back on the slide until it locks open.Â
Then use a punch or other sharp object to push out the takedown pin (located at the front of the frame just above the trigger guard), and release the slide stop lever (located at the left side of the frame just above the trigger guard).
Next, use a cleaning rod with a patch tip or bore brush attachment to clean the bore of your barrel.Â
Start by pushing the cleaning rod through from the chamber end of the barrel and work your way out.Â
Be sure to rotate the cleaning rod as you go to ensure that all sides of the bore are being cleaned.Â
Once you’ve reached the muzzle end of the barrel, remove the brush or patch tip and push the cleaning rod through a few more times to remove any debris that may be clinging to it.
Now it’s time to clean the rest of the barrel. For this, you will need a small brush and some solvent.Â
First, dip the brush in the solvent and then run it along the inside of the barrel, starting at the chamber end and working your way out.Â
Be sure to get all sides of the barrel, paying special attention to any nooks or crannies where debris might be hiding.Â
Once you’ve gone all the way around, take a clean patch and run it through the barrel to remove any residual solvent or debris.
The next step is to clean the slide assembly. For this, you will need a brush and some solvent.Â
First, remove the recoil spring assembly by pushing down on the spring guide rod (located at the front of the slide) and then pulling it out. Once the spring assembly is out, you can remove the barrel from the slide.
With the barrel removed, use a brush to scrub the inside of the slide (paying special attention to the feed ramp) with solvent.Â
Once you’ve gone over the entire surface, take a clean patch and run it through the slide to remove further residue, debris, and the chemicals you used.
Now that the slide is clean, you can reassemble the gun. Start by inserting the barrel into the slide and then replacing the recoil spring assembly.Â
Be sure that the spring guide rod is properly seated in the slot at the front of the slide, then push down on it and release the slide stop lever to lock it in place.
To reassemble the gun, insert the magazine and pull back on the slide until it locks open. Then use a punch or other sharp object to push in the takedown pin (located at the front of the frame just above the trigger guard) and release the slide stop lever (located at the left side of the frame just above the trigger guard).
Finally, wipe down the entire gun with a clean cloth to remove any fingerprints or other residue.
When Should You Clean Your Glock 19?
It’s generally accepted that you should clean your Glock 19 after every shooting session. But is that really necessary? Let’s take a look at five times when you should give your Glock 19 a good cleaning.
After Every Shooting Session
This is the most obvious time to clean your Glock 19. Whether you’ve been to the range or out in the field, it’s important to clean your gun after you’ve used it. This will help remove any dirt, debris or powder residue that could build up and cause problems down the road.
If It Gets Wet
If your Glock 19 gets wet, it’s important to clean it as soon as possible. Water can cause rust and other damage to your gun, so it’s best to get it cleaned up right away.
If It Gets Dirty
Even if you haven’t fired your Glock 19 in a while, it can still get dirty. Dust and other particles can build up on the surface of your gun, so it’s important to give it a good cleaning every so often.
Before Storage
If you’re going to be storing your Glock 19 for an extended period of time, it’s important to clean it first. This will help prevent any corrosion or other damage that can occur when a gun is stored for a long time.
After Modifications
If you’ve made any modifications to your Glock 19, it’s important to clean it afterward. This will help ensure that the modification doesn’t cause any problems down the road.
The Importance of Cleaning Your Firearm
Now, just in case you believe that all of the above hassle isn’t important, check out our ten reasons below on why you should take care of your firearm.
Ensure your firearm is always ready to use
No matter how well you take care of your gun, eventually, it will need to be cleaned. Firing and general wear and tear will cause dirt, dust and other debris to build up on the inside and outside of your gun. If this build-up is not removed, it can eventually lead to problems with your gun’s performance.
Keep your firearm accurate
A clean gun is a more accurate gun. The build-up of dirt, dust and debris on the inside and outside of your gun can cause it to fire inaccurately. By regularly cleaning your gun, you can help to keep it accurate.
Prevent rust and corrosion
Regular cleaning will also help to prevent rust and corrosion on your gun.Â
Rust and corrosion can damage the finish of your gun and eventually lead to problems with its performance.
Make sure your gun is safe to use
A clean gun is a safer gun. The build-up of dirt, dust and debris on the inside and outside of your gun can make it more difficult to handle and could eventually lead to an accident.
Extend the life of your gun
By regularly cleaning your gun, you can help to extend its life. A well-maintained gun that is regularly cleaned will last longer than one that is not.
Improve the value of your gun
If you ever decide to sell or trade your gun, a clean gun will be worth more than one that is not.Â
A clean gun is also more likely to function properly, which could come in handy if you ever need to use it for self-defense.
Protect your investment
A gun is a significant investment, and you should do everything you can to protect that investment.Â
Regular cleaning is one of the best ways to protect your gun and keep it in good condition.
Prevent jams and misfires
The build-up of dirt, dust and debris on the inside of your gun can eventually lead to jams and misfires. By regularly cleaning your gun, you can help to prevent these problems.
Make your gun easier to clean
If you wait too long to clean your gun, the buildup of dirt, dust, and debris will make it more difficult to clean.Â
By regularly cleaning your gun, you can make it easier to clean and help to prevent damage to your gun.
Because it’s the right thing to do
Regardless of your reason for cleaning your gun, it is ultimately the right thing to do. It is important to take good care of your gun and to keep it clean. Not only will it help to keep your gun in good condition, but it will also help to keep you and those around you safe.
Conclusion
Cleaning your Glock 19 is an important step in gun maintenance. Not only will it help to keep your firearm accurate and functional, but it will also help to prevent rust and corrosion.Â
By following the instructions in this guide, you can clean your Glock 19 quickly and easily. And remember, always clean your gun in a well-ventilated area.
Author bio:
Tomas is a digital marketing specialist and a freelance blogger. His work is focusing on new web tech trends and digital voice distribution across different channels.